Boot a computer with the floppy disk image ( use a USB floppy drive if the computer does not have one). 用软盘镜像启动一台计算机(如果计算机没有软驱,可以使用USB软驱)。
If a floppy is not appropriate ( for example, if the machine has no floppy drive), then any device that can be booted by your BIOS can be used. 如果软盘不适合(例如,如果计算机没有软盘驱动器),则可以使用能够通过BIOS引导的任何设备。
A floppy drive is usually ( fd0). 软盘驱动器通常是(fd0)。
The kernel will load kernel modules first, then detect hardware ( floppy drive, hard disk, network adapters, etc.), verify hardware configuration, and then scan and load device drivers. 内核将首先载入内核模块,然后检测硬件(软驱、硬盘、网络适配器等),检验硬件配置,然后扫描和载入设备驱动程序。
You can perform the preliminary boot steps from a supported device such as a floppy drive, CD, USB key, or a tiny partition on the main drive, and then use the external drive for everything else. 可以从支持的设备(如软盘驱动器、CD、USBkey或主驱动器上的微小分区)执行初始引导步骤,然后使用外置驱动器进行其他操作。
The boot drive is usually the first floppy drive ( designated A: in DOS and/ dev/ fd0 in Linux). 引导驱动器通常是第一个软盘驱动器(在DOS下指定为A:,而Linux下指定为/dev/fd0)。
Specify your floppy disk drive and then insert a floppy disk. 指定软盘驱动器,然后插入一张软盘。
Other users have reported that simply rebooting a few times with the same floppy in the floppy drive can lead to a successful boot. 其他一些用户报告过,用同样的软盘重新启动若干次才有一次能成功引导。
The selected floppy disk drive is not in use. Check to make sure a floppy disk is inserted. 所选驱动器无人使用,请检查并确认磁盘已插入。
You must specify the floppy disk drive and the number of disks you want to create. 您必须指定软盘驱动器和要创建的磁盘数。
Error copying files to floppy drive. 将文件复制到软盘驱动器时出现错误。
Setup is unable to get configuration information for the selected floppy disk drive 安装程序无法取得所选软盘驱动器的配置信息
Insert a formatted disk into your selected floppy disk drive. 请将格式化的磁盘插入选定的软盘驱动器。
After installation is complete, close the floppy drive Explorer window. 在完成安装后,关闭软驱浏览器窗口。
Please remove the client setup disk from your floppy drive now. 请从软盘驱动器中取出客户端安装盘。
The Home Networking wizard did not find a floppy drive on your computer. 家庭网络向导找不到计算机中的软盘驱动器。
No floppy drive was detected. 没有检测到软盘驱动器。
Most of the computer with BIOS set to check for the presence of an operating system in the floppy disk drive fist ( A:), and then testing the main hard drive. 大多数装有BIOS的电脑先开始检测软盘驱动器中是否存在操作系统,然后再检测主硬盘驱动器。
Check the floppy drive to make sure the door is closed and it contains the correct disk. 检查软盘驱动器,以确定驱动器门已经关闭且装有正确的磁盘。
Setup detected a disk in your floppy disk drive. Please remove all disks from floppy disk drives. Click OK to restart your computer. 安装程序发现驱动器有一张软盘,请取出所有驱动器的软盘。按确定,重新启动计算机。
The floppy disk drive reads information from a very thin disk that is inside a flat, square plastic case. 软驱是一个平整、正方的塑料盒子,它从一个非常薄的盘读出信息。
These are called the floppy disk drive and the CD-ROM. 它们叫做软驱和光驱。
The system is configured with floppy drive ( FDD). 系统已配置软驱。
It's very rare to install more than one floppy drive in a computer any more. 在一台计算机上安装不止一个软驱是非常罕见的。
A floppy disk drive is a storage device that reads data from and writes data to floppy disks. 软驱是一个从软盘里读取数据和写入数据存储设备。
Now all of the BIOS will allow detection of the floppy disk drive in the list of backward-shift, which can reduce the normal start-up time a few seconds. 现在所有的BIOS都允许将软盘驱动器在检测列表中向后移,从而可以将正常的启动时间减少几秒钟。
Typically, your computer will need a CPU, a RAM, a hard disk, a floppy disk drive, a CD-ROM drive, a main board or motherboard in your system unit. 典型的,你的计算机将会需要机箱里安装一个中央处理器,一个随机存储器,一个硬盘,一个软驱,一个光驱和一个主板。
If you created or used a Home Networking wizard Setup disk, remove the disk from the floppy drive. 创建或使用完家庭网络向导安装盘后,请从软驱中取出该盘。
The Calculation of the Location Error and Precision of the Floppy Disk Drive 软磁盘驱动器的定位误差和精度计算
My Edited Software to Revise the Head of Floppy Drive 自编软件校正软磁盘驱动器磁头